Safety Systems Built to Fit

Other Stove Manufacturers Safety Systems

Is Your Stove 

Up To Code and Safe ?

Has your Chambers range been “red-tagged” and put out of commission because it lacks a

safety system? 

Did you purchase a vintage stove for use in your kitchen only to get it “knocked-down” because it

failed to meet code? 

If so, please read further for an explanation of why you should be concerned and... a solution.

 Most early to older stoves were manufactured without safety systems simply because they were not in existence. The way you would lite the oven is with a match.

Unfortunately, through misuse this caused a 

great deal of accidents -- even deaths.

E-mail us at toac@sbcglobal.net for the exact instructions on the pictures required to build a Safety System for your Chambers stove.

You will receive detailed information

along with an estimate of cost.

Free phone consultation.

2 Years Warranty from Purchase Date

Your Chambers Safety System is Built to Last.

Fully Tested and Guaranteed!

Built for you by a professional patternmaker with four decades of Chambers experience.

Installation is easily done by a local               appliance technician.

 How could this happen? It doesn’t take much. You turn on the oven, then suddenly something as simple as a phone or door bell ringing pulls your attention away from manually lighting the oven. With the gas valve fully turned on, ‘raw’ gas rapidly fills the closed oven cavity. In short order you can imagine what can happen if just one spark – even from a light switch – can do when gas meets an ignition point.

 Today, with the vast increase of enthusiasts purchasing and installing vintage stoves in their homes, everyone should be aware that gas ranges must be up to code and safe!

 By adding a safety system into your stove, you will have the following benefits: 

• Standing Pilot – With the addition of a standing pilot for oven ignition, the need to use a match to manually light the oven is eliminated. If the pilot blows out due to a gust of wind or for any reason at all, the main flow of gas traveling into the oven will be cut off immediately.

• Safety Valve – The safety valve works as a guardian to permit or restrict raw gas from reaching its final destination point or ignition.  If the pilot is “blown out” or diminishes due to a lack of gas pressure, a signal, carried by a sensor that leads to the safety valve, hits a “red alert” that automatically shuts down the flow of fuel to the oven.

Few original Chambers ranges have a safety shut down system.

Due to thousands of letters that we received in regard to this problem, we felt it was time to

professionally construct a strong as steel safety system for the Chambers range.

This device can save your home, your life and your family! 

Everything you need for installation is included in one package.

All Parts are brand NEW and AGA approved!

TUBING IN ALL SIZES AVAILABLE

(We carry tubing including the rare size 5/32" used by Chambers.

All work is done in a Fully Licensed Facility.  Guaranteed 2 full years from delivery date!

 We build it for you!  Installation is easily done by a local stove service technician.

If you should need further assistance FREE HELP  over the phone

is included by a trained Chambers specialist with every order!

 LARGEST INVENTORY OF ANTIQUE CHAMBERS STOVES IN AMERICA

We have over 350 vintage Chambers ranges

and thousands of Chambers parts in our inventory plus

a full machine shop for custom fabrication work.

We can manufacture safety devices for

"A", "B" or "C" or most any Chambers stove manufactured since the 20s.

OVER 2,350 CHAMBERS STOVES NOW PROTECTED WITH SAFETY SYSTEMS

2,350 systems have been manufactured and installed to date with zero failures.

Your Chambers Safety System comes fully tested, guaranteed, and is fabricated by a professional patternmaker with decades of Chambers experience.

All New Parts - AGA approved!

E-mail us today at toac@sbcglobal.net for instructions on the exact

pictures we need to build your safety system.

You will receive detailed information

along with a free estimate of cost.

DON'T TAKE A CHANCE....

Get your Chambers Safety System and be up to code, up to date and safe today!

For All Other Stove Manufacturers Requiring SAFETY SYSTEMS

We carry safety equipment parts that can be adapted to most ranges, or 

can build a system for various stove types.

If your range has been knocked down for code violation or

you would like to eliminate match lighting your oven,

send pictures of your stove, the make and model, and information detailing your request to toac@sbcglobal.net or call (805) 643-3532.